Step 6: Install Glass Lamp Housing and Holder

Project Description

Category
How To Videos

Unpack glass lamp housing.


Place in the center of the cylinder on top of the saddles.



Lift one side of the housing to slide a 6 inch round band clamp to the inside of the support. Tighten the band lightly until lamp housing will not move on the saddle. Repeat on the other side.


Insert lamp holder in one end of the housing. The lamp (purchased separately) and its mogul socket will be fastened to this holder. Once the lamp and socket are installed, the holder can be moved towards the center until the light is in the desired location.


The mogul socket and lamp installed. Be careful when tightening the clamp on the mogul socket. Over-tightening could damage or break the ceramic socket.


<- Previous Step / Next Step ->